EG Aircraft thanks you for your purchase and wishes you much fun with the Lavochkin LA-5
CONTENTS OF THE BOX
===================
1 Lavochkin LA-5 "28" V1.0 EG Aircraft
1 Lavochkin LA-5 "52" V1.0 EG Aircraft
1 Gesture F1 (shooting or larguage )
1 Gesture F5 (activates rockets)
1 Gesture F6 (activates bombs)
1 Manual in french
1 Manual in English
1 Mirador VICE TARGET (for shooting practice)
1 DISPLAY Lavochkin LA-5 "28" EG Aircraft (69PE)
1 DISPLAY Lavochkin LA-5 "52" EG Aircraft (69PE)
FLIGHT CONTROLS
==================
1 / Up "arrow down" and down "arrow up"
2 / Turn right or left, respectively "right arrow" or "left arrow"
3 / Increase the power "PgUp" lower thrust "PgDown"
Voice commands Lavochkin LA-5
--------------------------------------
start = start engine
stop = stop engine
f = flaps
g = gear
br = brakes
s = switch flight mode (cruise or aerobatic / combat)
vice on = enabled
vice off = disabled
tcs on = enabled Tcs
tcs off = disabled
b = bomb or rockets firing (or F1)
p1 = rockets (or F5)
p2 = bombs (or F6)
c = change camera (fly / taxiing)
HUD = the plane gives you a hud on rezzing (accept the attachment)
mayday = Gets the plane 100 m higher in case it is stuck
DESCRIPTION OF HUD
==================
1 - airspeed indicator (km / h) (equivalence calculation 100m / s rl = 10m / s sl)
2 - Attitude indicator, (does not work in mouselook mode)
3 - Heading indicator (in degrees)
4 - Vertical speed
5 - Altimeter
6 - Power Indicator (PgUp / PgDown)
The combat system " VICE or TCS"
=================================
Machine guns (LMG 2x), the direction of fire is set to a maximum concentration at 100 m (crossing of two trajectories of fire)
For every rocket attack, four rockets in salvos (4 CMB), and you can fire 4 times without waiting for reloading. (16 CMB rockets per load )
For each launch of bombs, 11 CMB,distributed over an area of 20x20m, are released and you can cast off 4 times without waiting to reload, (44 CMB bombs per load)
Warning: This combat system should never be used for griefing. This is a fighter to be used only on targets that agreed. EG Aircraft is not responsible for the use of its aircraft by their owners.
It is the responsability of each pilot to obey the rules established by Linden Lab.
FLIGHT MODE
==========
This plane has 2 flight modes. The combat mode is automatically activated when you activate VICE or TCS.
GLIDING
==========
This plane can glide as in RL even with 0% throttle you still can glide if you maintain enough airspeed. (pitch is the key)
ADJUSTMENT OF THE GUNSIGHT (mouselook)
======================
you can adjust the hight of your gunsight.
put a target at 100 m in front of the plane. sit in the plane.
once in it, go to mouselook and write in chat: t+1 or t-1, t+10 or t-10, t+50 or t-50 to align it with the spot where the bullets enter the target.
You could write down the number so that the adjustement is faster on the next rezzing, and You can, also, create a gesture.
UPDATE
======
the updates of the plane are automatic, if an update is made you will get the latest version when you rezz your plane
=============
We thank Serena Lexington and Sally for their extensive test flights and good advices.
EG-Aircraft wish you good flights
To better serve you, all your comments, suggestions or questions may be submitted using the site:
https://egaircraft.bbactif.comto contact in world:
Erick Gregan
Kahlan Bingyi (sales and special orders)
Serena Lexington and Ashuri Hellwolfe (i3darkwulf) (demo's and technical questions not answered on the site)
Note: EG Aircraft (Erick Gregan) can not be held responsible for any changes made by © Linden Research, Inc. to "Second Life" or any malfunction during use of the aircraft with the quality of service offered by © Linden Research, Inc..
BEST SCULPTIES AND MESH RENDERING
==========================
For a correct display of your sculpties, see below.
LOD debug: Debug your settings LOD is a setting that will bring up all your sculpties perfectly. Just follow these steps:
1. Open the "Advanced" menu by Ctrl-Alt-D, or Opt-Ctrl-D on Mac.
2. Select "Debug Settings" in the list.
3. In the blank field, copy and paste this text:
RenderVolumeLODFactor
4. It is recommended to choose a value between 4 and 6.
Thanks to Ghanni Lane!
===============================
